The Use of FORCE 10,000D® for Sulfate Resistance Concrete – TB-0702

In areas where soils and ground water have high sulphate contents, or structures in a marine environment, concrete must be designed to resist sulphate attack. Solid sulphate salts do not attack concrete, but when present in solution they can react with hardened cement paste. When sulphates permeate concrete, expansive reactions occur with the cement hydration products: Ca(OH)2 (calcium hydroxide) and calcium aluminate and silicate hydrates. Rapid disintegration of the concrete can result. Three common forms of sulphates are calcium, sodium and magnesium. Calcium sulphate attacks only calcium aluminate hydrate, while sodium sulphate attacks the calcium aluminate hydrate and the Ca(OH)2. Magnesium sulphate attacks the calcium aluminate and silicate hydrates and the Ca(OH)2. Under certain conditions, attack by magnesium sulphate is more severe than by other sulphates. Concrete can be designed for a long service life in an aggressive sulphate environment with the incorporation of silica fume. Silica fume protects against sulphate attack in two ways. First, it decreases concrete permeability, which prevents the ingress of the sulphate solution. Secondly, silica fume chemically binds some of the free Ca(OH)2 in the paste preventing future reaction with sulphates. ACI 234 states that silica fume concrete has good resistance to sodium sulphate attack but does not work as well against magnesium sulphate.

Common preventive measures also include reducing the water/cement ratio to decrease permeability and providing air entrainment to allow room for expansive reaction by-products. The use of Type V cement, which is low in C3A (tricalcium aluminate), as a replacement for a higher C3A Type I cement, greatly increases sulphate resistance. However, the availability of Type V can be a problem. In addition, chloride resistance may be sacrificed when Type V cement is used. C3A chemically binds chloride ions leaving fewer ions available to attack embedded steel. In a concrete produced with Type V cement, less C3A is present to bind chloride ions than in Type I cement, and the potential for corrosion of reinforcing steel is increased. There are several references available showing superior sulphate resistance with the inclusion of silica fume in concrete. Research conducted by Rasheeduzzafar et. al., published in the ACI Materials Journal, March–April 1990, shows that Type I cement used with 20% silica fume provides more sulphate resistance than Type V cement. In these tests, cement paste cubes were immersed in a 5% sodium sulphate solution and tested for compressive strength at various ages over a 300-day period. Strength decreases measured the degree of sulphate attack. The conclusion of the work is that the use of Type I cement with silica fume can offer maximum protection against sulphate attack.